Your Rental Location
  • Request A Quote

MX150 Microprocessor Controller

The MX150 microprocessor is standard with the CTG product family. The MX150 microprocessor panel controls the operation and displays thes tatus of the transfer switch’s position, timer sand available sources. As an embedded digital controller, the MX series offers high reliability and ease of unattended operation across a range of applications.

Videos not available for this product.

360 View not available for this product.

  • Rating Range Switch Dependent
  • Transfer Type Application Dependent
  • Switch Type Application Dependent
  • Undervoltage Dropout for Source 1 and Source 2 75-98% of nominal

Call 440-838-7348 for rate information

Technical Summary

  • Rating Range
    Switch Dependent
  • Transfer Type
    Application Dependent
  • Switch Type
    Application Dependent

Controller Specifications

  • Undervoltage Dropout for Source 1 and Source 2
    75-98% of nominal
  • Undervoltage Restore for Source 1 and Source 2
    85-100% of nominal
  • Underfrequency Dropout for Source 1 and Source 2
    88-98% of nominal
  • Underfrequency Restore for Source 1 and Source 2
    90-100% of nominal
  • Delay for Engine Cool Down (U)
    0-10 seconds
  • Delay Transfer to Nonpreferred Source (W)
    0-5 minutes
  • Delay NeutralTransition Time Delays (DT,DW)
    0-10 minutes
  • Storage Temperature
    (-30˚C - 75˚C ), -22˚F - 167˚F
  • Operating Temperature Ambient
    40 - 400 amp molded shell (-20˚C to 65˚C) , -4˚F to 149˚F
    40 - 4000 amp all others (-20˚C to 60˚C), -4˚F to 149˚F

Features and Benefits

  • Digital timer and adjustments with 1 second resolution
  • Long lasting LED indicators and an easy-to-view LCD display
  • Inputs optoisolated for high electrical immunity to transients and noise
  • Digital voltage and frequency adjustments with1% resolution
  • Voltage and frequency sensing includes:
    –Voltage imbalance detection between phases
    –Under frequency sensing on source 2
    –3 Phase under voltage sensing on source 1(S1)
    – Normal and single phase sensing onsource (S2)
    – Emergency
  • Modular pre-signal option easily integrated into the system (e.g. elevator pre-signal and motor load disconnect)
  • Universal Motor Disconnect (UMD) available for programming to pre-signal, post-signal or both
  • Line voltage transients are isolated from the control board using remote transformers
  • Simplified major components and modules for easy replacement
  • On-board diagnostics including voltage frequency, control and timing
  • Nonvolatile memory – battery backup not required during normal source outage
  • External communication available through LonWorks/ModBus network interface (RS232,RS 422, and RS 485 are also available)
  • Maintained and momentary test positions are available to the controller
  • Test mode allows manual bypass of all transfer timers when applicable
  • Automatic daylight savings adjustment available

User-Friendly Operation

  • LEDs for continuous monitoring of switch position, source availability, exercise time delay operation and diagnostics
  • Simplified adjustment for voltage, frequency and time delay settings
  • Close differential 3 phase under-voltage sensing of source 1, factory standard setting 90% pickup,80% dropout (adjustable); under-frequency sensing of the source 1 factory setting 95% pickup (adjustable)
  • Voltage and frequency sensing of source 2,factory standard setting 90% pickup voltage,95% pickup frequency (adjustable)
  • Test switch (fast test/load/no load) to simulate normal source failure – automatically bypassed should source 2 fail
was successfully added to the cart! Request Quote